By:
Printer
Fixing the Printer Cartridge Problems - The steps are:
Soaking the print head surface with warm water, the possibility of a clogged head cartridge. Then one of the easiest solution is to soak the entire surface of the print head with warm water, if necessary, use a toothbrush with soft bristles, do not be harsh because it can lead to bubble ink becomes fluffy.Surgery cartridge. Follow the steps below:
Prepare equipment such as, ink bottles, injections, kitchen knives, paper towels and duct tape.
Open the top cover ink by using a knife, make sure the blade right in strain between the cover and the ink cartridge body. Halve like when you open the guava fruit. You will see a form of white cotton. Usually if a new purchase just a little ink. This proves that the producers just not as much ink to fill the cartridge capacity.
Lift the cotton and soak into the liquid IPA or warm water to clean, do not forget to clean the printer ink tanks also. Once clean, recharge by means of injected or shedding. Do it slowly, and it is recommended do not fill too full, so as not to flood.
Replace the cartridge cover and to secure it, you can use glue or tape. Cartridge is ready to use.
Boil cartridge with boiling water, if the above still fails possibility bubble case is not clogged, but the nozzles are in the cartridge has been frozen due to the ink dries. Perform surgical cartridge, lift the cotton and soak into the liquid IPA or warm water to clean, do not forget to clean the printer ink tanks also. Prepare clean water, then the entire input device cartridge that has been dissected and cleaned in a clean container containing water, turn on the stove allow the water to a boil then turn off the stove wait until the water becomes warm. Once the water gets warm take the cartridge devices and wipe with a clean cloth / dry. After that do not forget refilled ink according to the color, try to plug it back into the printer.